2x LED CAr Bulb White Very Bright LB321W LED CAN-BUS W5W T10 12V 5xSMD5050 Car Side Wedge Interior, Tail Light Lamp Blister Pack

Product No.:: LB321W
Shippingtime:: ca. 1-2 days (abroad may vary)

€ 7,95 EUR
excl. Shipping costs

Add to cart

Add to wish list

Bookmark

2x LED CAr Bulb White Very Bright LB321W LED CAN-BUS W5W T10 12V 5xSMD5050 Car Side Wedge Interior, Tail Light Lamp Blister Pack

Qty: 2x
Type: W5W
Socket: W2.1x9.5d
Number of diodes : 5xLED SMD
Diode Type : 3xSMD5050
Techology : CAN-BUS
Power: 0.72 W
Voltage: 12V DC

Replacement: W5W , T10 , R10, W2.1x9.5d
Application: parking light , side markers , door and glove compartment lighting, interior lighting , license plate lighting, signal control
The LED - bulbs are CAN-BUS for the new cars with CAN system and the blown bulb - suitable control.
The diode fulfills the function of the halogen bulb. Do not blink and does not delete like normal light bulb out .

Advantages of LED light bulbs :
Longer life
Low power consumption
Fast on and off
shockproof
easy installation
more vivid colors

Our diodes have an electrical system with a tolerance of up to 16V . Do not burn at the possible voltage rise . They are made on a Taiwanese rather than a cheap Chinese chip. Thanks to the Taiwanese components, the service life is longer. Bulbs produce more light (lumen) in comparison to products Chinese

Without approval: This light bulb has no E-mark and may not be used within the scope of traffic regulations, § 22a para 2 traffic regulations. Exclusively designed for the racing or rally operating outside of public roads, paths, squares or other public thoroughfares.

NO ERROR!

1 Note: CAN BUS LED bulbs has been specifically designed for newer models of VW, Audi, Mercedes, BMW, Volvo and many other manufacturers. It special and modern resistors and chips were installed so that the electronic lamp monitoring does not block the current flow to the status lights. The speedometer no error message therefore is displayed.
If in doubt, just order CAN-BUS lights so that you are always on the safe side! The CAN-BUS light is led car light which can solve the problem of error report!

2 Note: If you installed the common bulbs (non CAN-BUS) in cars equiped with Board Computer , CAN-BUS light will report that some bulbs can not work and display error (faulty bulb) on dash. That is because of the power of common bulb do not reach the requirement . How to solve this problem ? The answer is CAN-BUS auto bulbs.

3 Note: Every LED Bulb has Built-in current limiting resistor and diode to protect the LED from reversed polarity (+ –) installation. If you insert them into the socket and they don’t light, turn them oppositely and they will light.

Can I change the lamps themselves?
LED lamps have replaced the same properties as conventional lamps, so they are easy and fast with simple handles. Most refer to the manual of your vehicle and the necessary instructions on how the lamp covers can be easily removed.